Install Plesk

Justin

Use the One-Click Installer utility to perform a clean installation of the Plesk Panel in one step. Plesk-Panel install utility automatically determines your operating system and installs the latest version of an appropriate distribution in the typical configuration. One-Click Installer works only on Linux OS.

Before the installation, make sure that your chosen OS is supported by Plesk:
https://docs.plesk.com/release-notes/onyx/software-requirements/

To install the Plesk Panel, run one of the following commands on behalf of the root.

With wget utility, run:

wget -O - http://autoinstall.plesk.com/one-click-installer | sh

With curl utility, run:

curl http://autoinstall.plesk.com/one-click-installer | sh

With fetch utility, run:

fetch -o - http://autoinstall.plesk.com/one-click-installer | sh

lgobs

During installation of Plesk 12.5.30 i faced a few issues:

1. MySQL socket error.. resolution is to add:

bind-address = "your ip address" (without quotes)

into my.cnf file (/etc/mysql/my.cnf) under [mysqld] section.

2. Dovecot won't start.. resolution is, create new config file in /etc/dovecot/conf.d
name it for example: 5-ip4-listen.conf and add there:

# Listen on IPv4 only
listen = *

save it and Dovecot will start now.

lgobs

Next thing is FTPS (with TLS/SSL) - connection time out.
Resolution is to create Passive Ports config file in /etc/proftd.d/
for example: 40-passive-ports.conf

put there for example:

PassivePorts 30000 30400

and then in Plesk Firewall config you have to create new rule to open that ports ( Allow incoming from all on port 30000-30400/tcp )